The quality of the glue is directly related to the waterproof quality of the LED waterproof power supply

We all know that LED waterproof power supply is a power supply product with waterproof performance, but the reason why LED waterproof power supply can be waterproof is mainly realized by pouring glue. Pouring glue can not only prolong the life of the LED waterproof power supply, but also have a good heat dissipation effect.
1. The method of pouring glue for LED waterproof power supply: Before pouring glue, it is necessary to mix the glue in a ratio of 1:1 and fully stir it evenly, and then the potting can be carried out. How to adjust the vulcanization time: 1. Measurement: Accurately weigh the components A and B, and mix them according to the proportion. 2. Stirring: First stir the A component evenly, and then add the B component into the glue dispensing container with the A component and mix it evenly. 3. Pouring: After stirring evenly, the glue is potted. 4. Curing: The potted LED waterproof power supply is cured at room temperature. After the initial curing, it can enter the next process. It takes 1-2 hours for complete curing. In summer, when the temperature is high, the curing will be faster; in winter, when the temperature is low, the curing will be slower. Note: Once the mixed material should be filled and sealed in time, do not mix too much material at one time to avoid waste.
2. The reason why the LED waterproof power supply can be waterproof is mainly realized by the way of glue. Pouring glue can not only prolong the life of the LED waterproof power supply, but also have a good heat dissipation effect. So what are the precautions for LED waterproof power supply glue: 1. Before weighing the glue, it should be properly stirred to disperse the pigment (or filler) that sinks into the glue, otherwise it will cause slow curing, uneven viscosity and color etc. phenomenon. 2. The accuracy of the electronic scale is preferably 1 gram to ensure accurate proportioning. 3. The glue must be used up within 10 minutes each time, otherwise the viscosity will gradually increase and the fluidity will become worse. 4. When using the glued container to dispense glue again, the residual glue in the container must be cleaned up before continuing to dispense glue, otherwise it is easy to cause filaments in the glue and poor fluidity. How is the LED waterproof power supply glued? Just share it here. The quality of glue filling is directly related to the waterproof quality of LED waterproof power supply, so it is very important to choose good quality glue and master the method of glue filling.